How to attach outreach lifting cables
(The outreach cannot be raised on the model, the cables are purely aesthetic)
The model allows for the attachment of the cables that raise and lower the horizontal outreach. The pulleys, around which the cables wind, have a small hole through which a cotton thread, or similar, can be threaded.
The cables can be fed through the pulleys at the top of the crane and then through the corresponding pulleys on the horizontal outreach. Pull the thread tight, tie a knot and cut off the excess. Knots can be hidden behind the pulleys.
Each pair of pulleys holds three sets of cables, as can be seen in the following diagram.
The process can be repeated for the smaller pulleys, as shown below.